Cleaning And Maintaining - BGS technic 406 Manual De Instrucciones

Set up the driver clockwise direction.
4
The rotation speed should not be too high.
While working, hold the driver and the riveting equipment
firmly with both hands. Always press the equipment hard
5
against the workpiece. Start the driver clockwise until the
riveting is procedure finished.
Reverse the drive machine again anticlockwise in order to
6
expel the spent mandrel.
TROUBLE SHOOTING
Mandrel is jammed in jaw
Rivet cannot be set, jaw dirty or worn.

CLEANING AND MAINTAINING

Always disconnect the power plug from the power supply when cleaning and maintenance work.
Make sure that the drill driver can not be accidentally switched on.
Clean the tool not with harsh detergents or harsh chemicals.
DISPOSAL
Tool, accessories, end packaging should be sorted for environment-friendly recycling.
If your tool is not longer be used, then please keep in mind that many of its components consist of
valuable materials, which can be recycled.
Please do not dispose It In the rubbish bin, but check with your local council for recycling facilities in
your area.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Malfunction
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Remendy
Completely loosen the top black part of the blind
riveting attachment by turning counter clockwise
and remove it.
Turn the hex shank of the attachment by hand
counterclockwise until the collet of the jaws slide
upwards. If a rivet mandrel is jammed by the
jaws, carefully tap out or remove the jammed
piece by using pliers.
Clean or replace jaw.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed