Publicidad
Idiomas disponibles
Idiomas disponibles
Sensor signal receiving mode
The main unit automatically starts receiving transmission from outdoor
sensor for outdoor temperature & humidity.
The outdoor sensor will automatically transmit temperature and
humidity signal to the main unit after batteries inserted.
If main unit failed to receive transmission from outdoor thermo sensor
in first 3 minutes after the batteries inserted ("- - . –"display on the
LCD), hold the "SENDER" button for 3 seconds to receive transmission
manually. Signal strength icon "
Notes:
For best measuring, place the outdoor sensor outside and protected
from rainfall, strong winds and direct sunlight.
Transmissions between receiver (station) and transmitter (sensor) can
reach up to 100 m in an open area. In open areas there are no
interfering obstacles such as buildings, trees, vehicles, high voltage
lines, etc.
When powering or resetting, the device goes into radio reception mode
for 3 minutes. The signal strength icon "
Outdoor sensor channels
Press the "SENDER" button to view the outdoor sensor channel 1, 2 or
3 on the display. "1", "2" or "3" will be displayed under signal strength
"
" accordingly.
Only one sensor can be connected to each channel at a time.
To connect a sensor to a certain channel, select the channel 1, 2 or 3
on the channel switch on the backside of the outdoor sensor before
starting it. Select the corresponding channel on the station and hold
the "SENDER" button for 3 seconds to receive transmission manually.
Radio controlled time & time signal receiving mode
3 minutes after batteries are inserted or station is reset and main unit
finishes receiving the transmission from outdoor sensor, the clock
automatically starts to scan for the DCF-77 time signal. The time signal
reception icon"
" flashes on the LCD.
EN4
" flashes on the LCD.
" is displayed on LCD.
Publicidad
