auna UltraSonic Pulse V6-40 Manual De Instrucciones página 16

EN
16
OPERATION
Power source
This unit works with a built-in 7.4V 2600mAh Li-ion battery, it can be
recharged via DC 5V, 2A type C charging cable (included). Fully charge
the unit (around 4 hours) before using the product for the first time. The
playback time has about 2 hours after full charging. Unplug the type C
charging cable from the DC socket to work on the battery pack after full
charged. Plugging the type C charging cable while the battery pack is
attached initiates the charging of this battery, the charge indicator will turn
red, when the battery is fully charged, the charge indicator turn green. In
low power, the charge indicator red light flash constantly.
Basic function
TURNING THE UNIT ON/OFF
Press the power ON/OFF button to switch the unit on/off.
NOTE: When the unit is not providing the main function for 15 minutes, the
unit will automatically switch into standby mode. To turn on the unit again,
press „FUNCTION/ button.
ESD hints : The product maybe reset or not reset to operation of control due
to electrostatic discharge, just switch off and reconnect again.
Setting the function mode
To change the function modes, press the FUNCTION button to choose USB/
BT/AUX function.
Adjusting the volume
1. Rotate the VOLUME knob on the unit to increase or decrease the music
volume.
2. Rotate the GUITAR VOL. knob on the unit to increase or decrease the
guitar volume.
3. Rotate the MIC VOL. knob on the unit to increase or decrease the
microphone volume.
Bass adjustment
Rotate the BASS knob on unit to increase or decrease the bass effect that
best matches the music style.
Treble adjustment
Rotate the TREBLE knob on unit to increase or decrease the treble effect
that best matches the music style.