Installation Instructions - HAMPTON BAY 879-678 Manual De Instrucciones

PARTS INCLUDED FOR INSTALLATION (parts are not to
scale):
2 ea Bracket
2 ea Fixture
Mounting
Mounting Screws
Screws (#21)
2 ea Lock
Nuts (#2)

INSTALLATION INSTRUCTIONS:

1. Thread the Fixture Mounting Screws (#20) into the provided holes of the Mounting
Bracket (#19) as shown. Thread the Hex Nuts (#22) onto the Fixture Mounting
Screws (#20), as shown. Do not tighten the Hex Nuts (#22) at this time.
2. Pull the power supply wires out from the Outlet Box (#18), and mount the
Mounting Bracket (#19) to the Outlet Box (#18), using the Bracket Mounting
Screws (#21).
3. Attach the Black Supply Wire (#15) to the Black Fixture Wire (#11) and the White
Supply Wire (#16) to the White Fixture Wire (#12) using Wire Nuts (#14).
Connect the Fixture Ground Wire (#13) and the Supply Ground Wire (#17) together
using a Wire Nut (#14). Wrap all wire connections with electrical tape for a more
secure connection. Note: If you have electrical questions, consult your local
electrical code for approved grounding methods.
4. Place the Wall Plate (#3) over the Outlet Box (#18) and onto the Fixture Mounting
Screws (#20), and adjust the Fixture Mounting Screws (#20) until they protrude out
from the Wall Plate (#3) 1/4". Remove the Wall Plate (#3) and secure the position
of the Fixture Mounting Screws (#20) by tightening the Hex Nuts (#22) against the
Mounting Bracket (#19). Place the Wall Plate (#3) back onto the Fixture Mounting
Screws (#20), and secure it into place using the Lock Nuts (#2) provided.
5. After installing the fixture, caulk upper 2/3 of the Wall Plate (#3) to mounting
surface. Leave bottom 1/3 un-caulked for drainage of any water that might leak
into the enclosure. The manufacturer recommends a non-drying exterior caulking
material. A good example is a clear silicone rubber sealant for exterior use.
6. Installation is complete. Turn on power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
Page 6
1 ea Mounting
Bracket (#19)
(#20)
2 ea Hex
3 ea Wire
Nuts (#22)
Nuts (#14)
MISE EN GARDE :
1. Avant de commencer à installer ce luminaire ou à enlever l'ancien luminaire,
coupez le courant au niveau du disjoncteur ou retirez le fusible de la boîte de
fusible.
2. CONSULTEZ UN ÉLECTRICIEN
QUESTIONS CONCERNANT L'INSTALLATION ÉLECTRIQUE.
3. Si vous avez des questions autres que celles concernant l'installation électrique,
veuillez communiquer avec notre équipe du service à la clientèle au 1-877-527-
0313 ou visitez le www.homedepot.com. Vous devez fournir le numéro d'UGS
(879-678) ou le CUP (046335947191) à titre de référence.
4. CONSERVEZ votre reçu de caisse et ce manuel d'installation comme preuve
d'achat.
OUTILS NÉCESSAIRES POUR L'ASSEMBLAGE ET
L'INSTALLATION (non compris) :
Lampe à Lunettes
incandescence de
(100 watts max. ou sécurité
LFC équivalente)
Tournevis à Tournevis
tête plate Phillips
CERTIFIÉ SI VOUS AVEZ DES
Scellant de Pince
silicone pour à
l'extérieur dénuder
Ruban Coupe-
isolant fils
Page 19