Installation Instructions - HAMPTON BAY 240-236 Manual De Instrucciones

PARTS INCLUDED FOR INSTALLATION (parts are not to
scale):
1 ea Mounting
Bracket (#7)
2 ea Hex
Nuts (#9)

INSTALLATION INSTRUCTIONS:

1. Thread the Hex Nut (#9) onto the Nipple (#6). Thread the Nipple (#6) into the center hole of the
Mounting Bracket (#7). Do not tighten the Hex Nut (#9) at this time.
2. Pull the power supply wires out from the Outlet Box (#4), and mount the Mounting Bracket (#7) to the
Outlet Box (#4), using the Bracket Mounting Screws (#8).
3. Attach the Black Supply Wire (#5) to the Black Fixture Wire (#12) and the White Supply Wire (#16) to
the White Fixture Wire (#13) using Wire Nuts (#14). Connect the Fixture Ground Wire (#11) and the
Supply Ground Wire (#15) together using a Wire Nut (#14). Wrap all wire connections with electrical
tape for a more secure connection. Note: If you have electrical questions, consult your local electrical
code for approved grounding methods.
4. Carefully tuck all Wires and Wire Nuts (#14) into the Outlet Box (#4). Place the Fixture Pan (#1) over
the Outlet Box (#4), flush against the wall surface, making sure the Nipple (#6) feeds through the hole of
the Fixture Pan (#1). Adjust the Nipple (#6) so that it protrudes about ¼ inch from the surface of the
Fixture Pan (#1). Remover the Fixture Pan (#1) from the wall and tighten the Hex Nut (#9) against the
Mounting Bracket (#7). Replace the Fixture Pan (#1) over the Outlet Box (#4) and thread the Lock Nut
(#3) onto the Nipple (#6) to secure the Fixture Pan (#1) against the wall.
5. Proceed back to the Assembly Instructions.
6. Installation is complete. Turn on power at the circuit breaker or fuse box. Turn the light switch on to
activate the fixture.
Page 6
2 ea Bracket Mounting
Screws (#8)
1 ea Nipple (#6)
2 ea Lock
Nuts (#3)
3 ea Wire
Nuts (#14)