Initial Oil Fill; Battery Installation - Westinghouse WGen12000DF Manual Del Usuario

INITIAL OIL FILL

THIS GENERATOR HAS BEEN SHIPPED WITHOUT
OIL. Do not attempt to crank or start engine before it has
been properly serviced with recommended oil. Failure to
add engine oil before starting will result in serious engine
damage.
Use of 2-stroke/cycle oil or other unapproved oil types
can cause severe engine damage that is not covered
under warranty.
The included, recommended oil type for typical use is
10W-30 engine oil. If running the generator in extreme
temperatures, refer to the following chart.
1. On a level surface, remove the oil fill cap.
2. Using the supplied funnel and oil, add the oil into the
engine.
3. Replace the oil fill cap and tighten securely.
NOTICE
NOTICE

BATTERY INSTALLATION

Battery posts, terminals contain lead and lead
compounds. Wash hands after handling.
The battery shipped with the generator has been fully
charged. A battery may lose some charge when not in
use for prolonged periods of time. See the BATTERY
MAINTENANCE section for battery charging procedure.
Note: Once started, the generator will charge the battery
after 30–60 minutes of use.
1. Remove the two battery plate bolts and battery plate.
Tilt the battery forward and remove.
2. Connect the positive (+) battery cable (red boot) to
the positive (+) battery post. Secure the boot over the
battery post.
3. Connect the negative (-) cable (black boot) to the
negative (-) battery post. Secure the boot over the
battery post.
4. Install the battery in the battery tray. Install the battery
plate and bolts. Tighten the bolts securely.
Westinghouse Outdoor Power Equipment, LLC | 13
ASSEMBLY