Wiring Harness; Guarita Ip Connection - ANATEL LN-104C EMF Instrucciones De Instalacion Y Uso

04 - WIRING HARNESS

05 - GUARITA IP CONNECTION

1 - Red - 12V x 1A power input;
2 - Black - GND power input;
3 - Blue - Signal input of the sound signaling BUZZER / Signal
input of the status signaling frontal LED;
4 - Green - Wiegand output DATA 0;
5 - White - Wiegand output DATA 1;
6 - Gray - Opened door sensor timeout of 20 seconds (intermittent
Frontal
beep after this period);
LED
7 - Purple - Reserved;
8 - Yellow - Reserved.
Wiring
NOTE: To disable the open door sensor, connect the gray wire
to the black wire (GND).
POWER 12VDC 1A
Fix the holder on the choose local for the reader installa-
tion.
Pass the wiring that will be connected to the reader wiring
through the holder central hole. Connect the wiring and
isolate it;
Place the reader aligning the top part and fit it over the
guides;
Fit the holder in the bottom guide and then insert the screw
until fasten it.
ENGLISH
1 - LN 104C EMF reader;
2 - 12VDC 1A power source;
3 - Guarita IP module
13