VOLTOMAT HEATING RAH-111956/2 Manual De Instrucciones página 53

OPERATION
Note:

This appliance is equipped with a remote control for operation. One piece of CR2032 battery should be used
for it.

When the heater is first used you may detect some smell and smog. This is normal. The protective oils used
on the element during production will burn off at the first use. Allow the appliance to heat up in an open
environment and the smell will disappear over a short period of time.

Be sure not to use the same socket with other high-power appliance to avoid overloading.
1. Plug in the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the power
switch to position "I". A beep sound will be heard. The appliance is standby with "— —" flashing on the
digital display.
2. Press the on/off button "
temperature is 35℃ and 5 seconds later the digital display shows the current ambient temperature.
3. Press the button "
to 45℃. The corresponding temperature value will be shown on the digital display. The set temperature will
be activated in 5 seconds without any other operation and then the digital display will show back the ambient
temperature.
The appliance will automatically maintain your setting temperature with the working light on and off. The
unit will stop working when the ambient temperature is above the setting temperature by 3℃ and resume
work when the ambient temperature is below the setting temperature by 1℃.
4. Press the timer button "
increasing/decreasing 1 hour, within 9 hours. The corresponding timer value will be shown on the digital
display. The set timer will be activated in 5 seconds without any other operation and then the digital display
will show back the ambient temperature.
Note: After timer and temperature are set, the digital display will show the set working time and the ambient
temperature alternatively. If you do not set the timer and only set the temperature, the digital display will
show the ambient temperature only.
5. This appliance is also equipped with ECO function and lock function.
- ECO function: You can press the button "
temperature/timer display will be on. Press the button again, the working light will illuminate again.
-
Lock function: You can press the button "
function will be activated. All buttons on the remote control will be invalid when lock function is
activated. To deactivate the lock function, press the button "
" ".
6. After use, press the button "
switch to position "O" and unplug the appliance.
Electric memory function
After use, turn off the appliance by the on/off button but not press the power switch to position "O". Under this
condition, if you turn on the appliance again, the appliance will keep working with the temperature you set last
time and the timer function will lose efficacy.
CLEANING AND MAINTENANCE
Before maintaining, please unplug the appliance and make sure the heater has cooled down completely.

Please use soft cloth to wipe the dust on the appliance's surface.

" on the remote control to start setting your heater. The default setting
" or " " to set your desired temperature by increasing/decreasing 1℃, between 5℃
" and then the button "
" on the remote control and the appliance will be in standby. Press the power
" or " " to set your desired working time by
" to turn off the working light and only the
" and then immediately the button "
- 52 -
" and then immediately the button
", the lock