Directed 3121 Guia Del Usuario página 18

Black/White Antenna
This wire is the antenna for the control module to receive com-
mands from the transmitter. Do NOT cut this wire.
Note: The antenna wire should not be bundled with the other har-
ness wires as this will reduce the effective range of the transmitter.
Keep the antenna wire as straight and horizontal as possible.
Also, keep the antenna wire as far away as possible from metal.
Brown Siren (+) or Horn (-)
• Siren (+): If using the siren supplied with the system, connect
this wire to the Red wire of the siren. The siren's black wire
should be connected to chasis ground.
• Horn (-): This wire supplies a (-) 200mA output which can
be used to honk the vehicle's horn. This wire outputs pulses
during arm/disarm and when the alarm has been triggered.
Note: By default, this wire is (+) siren output. To change to (-) output
for horn, change feature No. 5 to Negative
Yellow (+) Ignition
Connect this wire to an ignition wire. This wire must show (+) 12V
with the key in the run position and during cranking. Make sure
that this wire cannot be shorted to the chassis at any point
16
© 2018 Directed. All rights reserved.