English; Safety Recommendations - Krups DUOTHEK THERM STEEL Manual De Instrucciones

English

Safety recommendations

Read the instructions carefully before using
•
your appliance for the first time. Incorrect
use will absolve Krups of all responsibility.
Do not leave the appliance within the reach
•
of children.
Before connecting the appliance, check that
•
the supply voltage of your installation
matches that of the appliance, and that the
power outlet includes an earth wire.
Wiring instructions for U.K and Ireland
only :
APPLIANCES WITH FITTED PLUG
Important : For your convenience this
appliance is supplied complete with a plug
incorporating a 13 amp fuse.
In the event of replacing a fuse in the plug
supplied, a 13 amp fuse approved by ASTA to
BS1362 must be used.
If the socket outlets are not of the 13A BS
1363 type, and therefore do not accept the
plug connected to this appliance, cut off the
plug.
When cut off, this plug is a shock hazard if
inserted into a socket outlet and must
therefore be disposed of safely.
If the fuse cover is detachable, never use the
plug with the cover omitted. Replacement
covers can be obtained from your service
agent.
Fit the appropriate plug according to the
instructions in paragraph "Fitting a plug".
With alternative plugs a 15 amp fuse must be
fitted either in the plug or adaptor or at the
main fuse box.
APPLIANCES WITHOUT FITTED PLUG
FITTING A PLUG - IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
GREEN & YELLOW
BLUE : NEUTRAL
BROWN : LIVE
As the colours in the mains lead of this
appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW
must be connected to the terminal in the plug
: EARTH
which is marked with the letter 'E' or by the
earth symbol or coloured green or green
and yellow. The wire which is coloured BLUE
must be connected to the terminal which is
marked with the letter 'N' or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter 'L' or coloured red.
This appliance is manufactured to conform to
the Low Voltage Electrical Equipment (Safety)
Regulations 1989 and is designed to comply
with BS 3456. It complies with the
requirements of the EEC Directive (89/336/
EEC).
Any connection error will nullify the
guarantee.
Your appliance is intended for domestic use
•
only, and only within the home.
Disconnect your appliance during prolonged
•
absence and when cleaning it.
Do not use your appliance if it is not
•
working correctly, or if it is damaged. In such
a case, call the Krups approved service
centre.
Any operation, other than normal cleaning
•
or servicing, by the customer, should be
performed by a Krups approved service
centre.
If the power cable is damaged, do not use
•
the appliance. In order to avoid all danger,
have the cable replaced by the manufactu-
rer, its after-sales service, or similarly
qualified people.
Do not put the appliance, the power cable,
•
or the power plug into water or any other
liquid.
Do not allow the power cable to hang
•
down.
The power cable must never come close to,
•
or in contact with, the hot parts of your
appliance, or close to a heat source or a
sharp edge.
For your safety, use only Krups accessories
•
and spare parts suitable for your appliance.
Do not disconnect the power plug from its
•
socket by pulling on the cable.
Do not use the pourer or the insulated flask
•
(according to model) in a microwave oven or
on kitchen hotplates.
Do not put hot water into the reservoirs.
•
11