Connecting To The Power Supply - Krups BeerTender 0828213 Manual Del Usuario

12°C
30°C
Remove the BeerTender appliance from the packing
container and place it on a dry, clean, level, stable
surface that is sufficiently large to accommodate it.
The temperature of the room must be between 12°C and
30°C. If ambient temperatures is outside these brackets,
your BeerTender will not be able to deliver the
temperature you programmed.
Set the drip tray and grate in place at the front of the
appliance. Make sure the drip tray is properly fitted and
positioned.
Do not install the appliance near sources of heat or in
places exposed to direct sunlight.
Note: keep in mind that during use the drip tray will have
to be emptied and rinsed regularly. When the BeerTender
system is not being used, you can remove the drip tray
and place it elsewhere to save space.
Warning! The drip tray must be positioned on a level
surface and must not jut out from the surface it is resting
on.
After installing the BeerTender appliance you must clean
the dispensing spout; this is the only part of the
appliance that will come into contact with the beer.
It is vital that you wash the dispensing spout before using
the appliance for the first time and at least every time a
new keg is connected inside the BeerTender system.
This part can also be washed in a dishwasher.
To clean the spout, remove it from its housing.
After washing the spout, screw it back into place.

Connecting to the power supply

Electricity can be dangerous! Therefore you must always
scrupulously abide by the safety rules.
The appliance must be plugged into a suitable, properly
installed electric socket with an earth connection.
The voltage of the appliance has been set in the factory.
Check that the mains voltage matches the voltage
indicated on the rating plate on the rear of the appliance.
Make sure the main switch on the right is set on "0"
before connecting the BeerTender to the mains.
11