Spanset Clima Harness Instrucciones página 6

* Local abrasion as distinct from general wear may be caused by the passage of the webbing over sharp
edges or protrusions while under tension and may cause serious loss of strength. Slight damage to
outer fibres and occasional yarn may be considered harmless but serious reduction in width or thickness
of the webbing or serious distortion to the weave pattern should lead to rejection.
A harness should be immediately removed from service after being subjected to any fall, or if in any
doubt about the harnesses condition. The harness shall not be used again until it is confirmed in
writing by a competent person that it is acceptable to do so.
The harness may be cleaned or disinfected if required. The following procedure must be adhered to. Use
hand hot water with a mild detergent or disinfectant, then rinse with clean water, and allow drying
naturally, out of direct sunlight. Any detergent or disinfectant used must be compatible with polyamide,
and polyester.
If you require more information please contact SpanSet.
All equipment should be stored and transported in the following manner:-
• To prevent contact with sharp objects that may damage the fibres of the webbing.
• Away from harmful substances such as acids, alkalis, fuel, paints, solvents that harm polyester and
nylon fibres.
• Kept in a cool dry place free from direct sunlight, to prevent degradation of the fibres from ultraviolet
radiation.
• Wetness of the equipment should be allowed to dry naturally away from direct heat.
SPANSET PRODUCTS AND TRAINING
SpanSet can supply other items of equipment that are compatible with this product.
These include: EN361 fall-arrest harnesses, a variety of EN362 connectors, work positioning belts,
and adjustable safety lines. SpanSet also produces/supplies a full range of fall arrest and access
equipment.
SPANSET offers training either on site or at our own premises, in all aspects of height safety. Courses
are accredited under our registration to ISO 9001, and certificates are issued on successful completion.
Although it is not compulsory, for the safety of all users SPANSET recommends you take advantage of
this training service, please contact us for further details.
SpanSet Ltd, Telford Way, Middlewich, Cheshire, CW10 0HX
Tel: +44(0)1606 737494
Fax: +44(0)1606 737 264
www.spanset.co.uk