Troubleshooting And Repairs - Starmix ISC CLDC ISC Batrix L 36-18V Instrucciones Para El Manejo

9

Troubleshooting and repairs

l WARNING!
Improperly repaired vacuum cleaners pose a danger to the user!
▶ Repairs should only be carried out by qualified personnel, e.g.
customer service.
▶ Only use original spare parts.
Fault
Decrease in suction power
Vacuum not starting
The vacuum cleaner does not start
when the tool is switched on in >AUTO<
mode.
PE emptying and disposal bag is sucked
onto the filters
Class M vacuum cleaner: dust in the
container with non-woven filter installed
Static discharges via operator
Fill indicator lights
All capacity and signal
display LEDs flash
One capacity or signal
display LED flashes
Fast beeping (1/10 s on, 1 s off)
Continuous beep
3 s continuous beep
Do not proceed to make any further interventions – contact the central customer service workshop.
34 - en
Malfunctions are not always due to defects of the vacuum
cleaner.
Possible cause
Filter dirty
Filter bag full
Container full
Motor protection filter clogged
Nozzle, tubes or hose clogged
Cover not properly closed
Water sensor switched off
Vacuum cleaner in standby mode
>AUTO<
Battery defective
Battery not inserted correctly
Battery empty
Contacts defective or corroded
Pairing of the cordless control failed
Cordless control defective
Position of rotating slider incorrect
Position of rotating slider incorrect
Electrostatic discharge not guaranteed
Filter full
Container full
Hose clogged
Battery error
Only one 18V battery pack inserted
Battery/batteries empty
Battery pack will be empty in approx.
20 s
Advance warning shortly before
switching off
Water level in container full
NOTE
Solution
Clean
Replace
Empty
Clean
Clean
Close
Empty container
Set the operating mode / speed control dial to >ON<
(see chKap. 3 „Display and control elements" on
page 27)
Replace
Insert correctly
Replace / charge
Contact a specialist workshop
See the manufacturer's instructions for cordless
control.
Set the rotating slider to ▲OPEN (see Kap. „Insert-
ing PE emptying and disposal bags*" on page 29)
Set the rotating slider to ▲CLOSE (seeKap. „In-
serting a non-woven filter bag*" on page 29)
Use electrically conductive suction hose or replace
defective EL hose
Filter cleaning
Empty container
Remove vacuumed material from hose
Remove and reinsert the battery packs
Insert the second 18V battery
Charge the battery/batteries
Charge the battery/batteries
Charge the battery/batteries
Empty container