Publicidad
This operation must be made on all the groups at the end
of each working day
1) Using a brush, clean the cover gasket.
3) Pour in a packet or dosing cupful of detergent powder
button. After a few seconds, press the STOP button. Repeat
this operation a few times.
sponge.
6) Flush each dispenser unit with water for about 30
seconds.
1) Put a liter of cold water in a suitable container and add
detergent.
in the same detergent solution, using a small sponge.
4) Flush thoroughly with cold water.
Using a clean sponge, wash with hot water removing any
organic residue present. Rinse carefully.
To clean the inside of the steam nozzle, follow these steps:
Turn the nozzle towards the cup tray and carefully activate
steam dispensing at least once.
Remove the grille from the basin, extract the grille sections and
complete the cleaning operation under running water.
When the machine has not been used for more
than 8 hours, and in any case once a day, the
internal components must be washed before
use, in accordance to the following instructions:
dispense from each group for one minute.
1
At the end of the working day, pour about a liter of hot water
into it to remove any discharge residues.
Use a soft cloth and cleaning products WITHOUT ammonia
or abrasives, removing any organic residue present in the
work area.
N.B. Do not spray liquids into the panel slots.
Dispense hot water repeatedly (using the relative com-
mand) until at least 6 liters of water have been dispensed
from the 2-group machine.
Steam
using the appropriate commands.
27
2
3
Publicidad
