Troubleshooting - TRAPP 48L22AH0x8A Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Will not start
Hard to start
Engine will not turn
over
Engine clicks but
will not start
140

Troubleshooting

Probable cause
1. Out of fuel.
2. Engine not "choked" properly.
3. Engine flooded.
4. Bad spark plug.
5. Weak/discharged battery.
6. Dirty air filter.
7. Dirty fuel filter.
8. Water in fuel.
9. Loose or damaged wiring.
10. Carburetor out of adjustment.
11. Engine valves out of adjustment.
1. Dirty air filter.
2. Bad spark plug.
3. Weak or dead battery
4. Dirty fuel filter.
5. Stale or dirty fuel.
6. Loose or damaged wiring.
7. Carburetor out of adjustment.
8. Engine valves out of adjustment.
1. Clutch/brake pedal not depressed.
2. Attachment clutch is engaged
3. Weak or dead battery.
4. Blown fuse.
5. Corroded battery terminals.
6. Loose or damaged wiring.
7. Faulty ignition switch.
8. Faulty solenoid or starter.
9. Faulty operator presence switch(es).
1. Weak or dead battery.
2. Corroded battery terminals.
3. Loose or damaged wiring.
4. Faulty solenoid or starter.
Solution
1. Fill fuel tank.
2. See "To start engine" in Operation
section.
3. Wait several minutes before attempting
to start.
4. Replace spark plug.
5. Recharge/substitute battery.
6. Clean/replace air filter.
7. Replace fuel filter.
8. Drain fuel tank and carburetor, refill tank
with fresh gasoline and replace fuel filter.
9. Check all wiring.
10. See "To adjust carburetor" in Service
Adjustments section.
11. Contact an authorized service center/
department.
1. Clean/replace air filter.
2. Replace spark plug.
3. Recharge or replace battery.
4. Replace fuel filter.
5. Drain fuel tank and refill with fresh
gasoline.
6. Check all wiring.
7. See "To Adjust Carburetor" in Service
Adjustments section.
8. Contact an authorized service center/
department.
1. Depress clutch/brake pedal.
2. Disengage attachment clutch.
3. Recharge or replace battery.
4. Replace fuse.
5. Clean battery terminals.
6. Check all wiring.
7. Check/replace ignition switch.
8. Check/replace solenoid or starter.
9. Contact an authorized service center/
department.
1. Recharge or replace battery.
2. Clean battery terminals.
3. Check all wiring.
4. Check/replace solenoid or starter.
www.trapp.com.br

Publicidad

Tabla de contenido
loading

Productos relacionados para TRAPP 48L22AH0x8A

Este manual también es adecuado para:

48g24g60x8a54g26g60x8a

Tabla de contenido