Fein BOP6 Instrucciones De Uso página 13

OBJ_BUCH-0000000005-001.book Page 13 Friday, February 5, 2010 8:57 AM
Working instructions.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Selecting the rotation direction
(figure 6).
Set the Rotation selector switch to right or
left rotation as required.
Adjust the Rotation selector
WARNING
switch only when the machine
is at a complete stop.
Adjusting the gear setting (figure 7).
Adjust gear setting 1 to work with low speed
and high torque. This gear setting is suitable
for drilling with large drill bit diameters.
Adjust gear setting 2 to work with high speed
and a lower torque. This setting is suitable for
drilling with small drill bit diameters.
The material-dependent gear setting can be
determined by practical testing.
Adjust the gear setting only
WARNING
when the machine is running
down or at a complete stop.
en
13