Preparing The Setup Wizard; Power Cord; R03/Aaa Batteries - Marantz NR1402 Antes De Empezar

ENGliSh DEutSch

Preparing the Setup Wizard

This section describes how to prepare the Setup Wizard before use.
n Do not plug the power plug of the main unit into the wall socket until these preparations are complete.
n Speaker connections are performed using the Setup Wizard. Do not connect the speakers yet.
What you need for this step
Speaker Speaker cable
(sold separately) (sold separately)
C
FL FR
SL SR
• Prepare enough for the
number of speakers you
will use.
Subwoofer (with built-in amplifier)
(sold separately) (sold separately)
TV
(sold separately) (sold separately)
Remote control unit / Setup microphone
R03/AAA batteries (supplied)
Power cord (supplied)
2
FRANçAiS itAliANo ESpAñol
1
Place and layout speakers
Before installing the speakers, connect the speaker cables to the speakers. For details on how to connect the speaker cables, see the
speaker instruction manual.
Connect the speaker cables to the main unit using the Setup Wizard.
n When 5.1-channel installed
Audio cable
SL
HDMI cable
Front speaker (L)
FL
FR Front speaker (R)
(supplied)
C Center speaker
SW Subwoofer
SL Surround speaker (L)
SR Surround speaker (R)
NEDERlANDS SVENSKA
FL FR
SW
C
z1
z2
SR
Listening position
z1 22˚ – 30˚ z2 120˚
• Install the surround speakers in a position 60 to 90 cm higher than
ear level.
Surround
speaker
Front
speaker
60 – 90 cm
GViewed from the sideH