Insertion Tool - Chicago Pneumatic RX 2 Instrucciones De Operación Y Seguridad

RX 2, 3, 4, 6, 8
11. After mounting the breaker, carefully extend and
retract the bucket cylinder to its full extent in
each direction. It is important that the cylinder
can be fully extended and retracted without any
difficulty.
Connecting the hydraulic hose
12. Circulate the hydraulic oil before connecting the
hydraulic breaker. This is to make sure that the
hydraulic oil is clean. Use the same routine when
changing the hydraulic oil hose. For further
information see "The hydraulic oil".
13. Connect the pressure and return hose.
14. Run the hydraulic oil through the carrier's oil
filter for approximately 3 minutes to make sure
that the hoses are clean.

Insertion tool

Selecting the right insertion tool
Conical moil point
Chisels and spades
9800 1050 90 | Original instructions
> Very good penetration
> Regular spread of wedge
action
> No torsion effect
> Very good spread of wedge
action
> Good penetration
> Torsion effect
Safety and operating instructions
Blunt tool
Mounting and dismounting the insertion
tool
WARNING Running engine
Changing the inserted tool or accessories while the
carrier's engine is running can cause serious injury.
► Secure the carrier against involuntary activation.
Before you start mounting or dismounting the
insertion tool, do the following:
1. Place the hydraulic breaker on timber support
blocks. The boring on the back side of the
hydraulic breaker has to remain free.
2. Shut off the carrier's engine.
3. Remove two plugs from the hammer box, the
first at the split pin and the second at the retainer
pin.
Dismounting the insertion tool:
> Very good energy
application
> Optimum breaking effect
> No torsion effect
15