Operation; Preparation Before Breaking; Operating - Chicago Pneumatic RX 2 Instrucciones De Operación Y Seguridad

RX 2, 3, 4, 6, 8

Operation

NOTICE The hydraulic breaker or the inserted tool
is not to be used as a lifting device. When lifting
heavy components use the hook on the carrier arm.

Preparation before breaking

Operating temperatures
The operating temperatures of the hydraulic breaker
are between – 20 ºC and + 80 ºC.
CAUTION Temperature hazard
The hydraulic breaker and the hydraulic oil system
of the carrier can be damaged if the hydraulic breaker
is used at higher or lower temperatures.
Only start the hydraulic breaker when the
►
hydraulic oil has reached the proper operating
temperature.
If the ambient temperature is below – 20 ºC, you
►
should warm up the insertion tool and the
hydraulic breaker before use.
► If the oil temperature exceeds + 80 ºC, you must
not use the hydraulic breaker as the oil quality
becomes inadequate which severely shortens the
life time of seals and O-rings.
Engine rpm
Too high engine rpm only results in increased fuel
consumption and increased oil temperature. Adapt
the engine rpm to the recommended value to give
the correct operating oil flow.

Operating

Risk area
Before starting the hydraulic breaker, make sure that
no persons are in the risk area, 20 meters both
horizontally and vertically from the hydraulic
breaker.
9800 1050 90 | Original instructions
Safety and operating instructions
Breaking
CAUTION Machine and tool hazard
Continuous operation at full extension and/or
retraction can result in damage to the hydraulic
cylinders.
► Always avoid operating the breaker with the
cylinders fully extended or retracted.
Reposition the carrier and/or boom to avoid fully
►
extended or retracted cylinders.
Pay attention and look at what you are doing.
►
Never start the hydraulic breaker until both carrier
and the hydraulic breaker are in the correct position.
17