Setup; Set Temperature Unit, Mtc Temperature And Temperature Correction Coefficient; Set Tds Factor - OHAUS a-AB23EC Manual De Instrucciones

EN-8

3. SETUP

3.1 Set temperature unit, MTC temperature and
temperature correction coefficient
1. Press the Exit button to turn the meter on.
2. Long press the Temp. button to enter setting.
3. The symbol ° C is flashing.
4. Press the
5. Press the Read/Enter button to confirm your selection.
6. Continue to set the MTC temperature by using
7. Press the Read/Enter button to confirm the setting.
8. Continue to select the Reference temperature by using
9. Press the Read/Enter button to confirm the setting.
10. Continue to set the temperature correction coefficient by using
adjust.
11. Press the Read/Enter button to confirm the setting.
Note:
1. The default MTC temperature value is 25° C (77° F).
2. ° C = 5/9 (° F - 32).
3.2

Set TDS factor

To set TDS factor:
1. Long press the TDS-F button.
2. The default value 0.50 is flashing.
3. Press the
4. Press the Read/Enter button to confirm the setting.
or button to switch between ° C and ° F.
or button to adjust the value.
a-AB23EC Bench Conductivity Meter
or button to adjust.
or button to adjust.
or button to