Zoeller APak Instrucciones De Instalación página 3

Connect the two conductors from the control or mechanical switch to either pair of input terminals on the bottom of the alarm unit (see Figure B).
The control switch operates on low voltage to reduce shock hazards. The second input may be used to connect a second switch or dry contacts
from another device.
OPERATION AND TESTING
Check and test your installation by lifting the float manually (see Figure E or G). The alarm unit will indicate an alarm condition by beeping and
lighting a red LED above "Input 1". The alarm may be silenced for 24 hours* by briefly pressing the Silence button. Once silenced, the LED changes
to a flashing state and the audible horn will not sound. Once the high water condition is remedied, the alarm should be reset by holding the Silence
button for 2 seconds. Zoeller Company cannot be responsible for damages caused by faulty or negligent installation of this device. We respectfully
suggest you engage the services of a qualified, licensed electrician or service person. Hold the Silence button for more than 4 seconds to test once
per week to verify proper operation.
During a power outage, the APak
batteries installed, the alarm will sound every 5 seconds.
*24 hours is the default setting. This and other settings may be changed from Z Control
Item
1
2
3
4
CLAMP DETAIL
7" (17.8 cm)
TETHER LENGTH
FOR ALARM FLOAT
Figure F
SK1301F
CONTROL/MECHANICAL SWITCH WIRING
For units without internet connectivity, see the standard APak
will beep every 30 seconds until the power is restored. If a high water alarm occurs during power outage with
®
Description
Clamp, #36 worm-SS
Supply, power (service part)
Switch, vertical reed (service part)
Switch, mechanical float
© Copyright 2021 Zoeller
7"
Figure G
10-4011, 10-4012.
®
Cloud.
®
Models 10-4013-A
3/16
Qty thru
Current
1 001766
1 154018
1 154033
1 N/A
Co. All rights reserved.
®
3
CLAMP
DETAIL
ALARM
LEVEL
SK1301G
10-4014-A
3/16
thru
Current
001766
154018
N/A
10-2060
SK3113