Zoeller APak Instrucciones De Instalación página 6

Select the APak
*AP Mode is when the APak is broadcasting its "name", or SSID. The SSID is in the format ZCTL_APak_xxxx where "xxxx" is the first 4 digits of your
APak's Device ID (See Figure I). The APak's SSID will show up in your phone/tablet/computer's list of available WiFi networks, and selecting it will
give you direct connectivity to the APak. This is required in order to give your APak the password credentials needed to connect to the WiFi network
of your choice.
2. Standing near the APak, use your phone, tablet, or computer to look for the APak's SSID in your WiFi settings (see Figure I). It will look like "ZCTL_APak_
xxxx" where "xxxx" is the first 4 digits of your APak's Device ID. Select this, and be sure your device displays a check mark or similar indicator that you
are connected to the APak's local network. If so, 2 things will happen:
1. The Z Control LED will flash quickly.
®
2. A Z Control setup screen (See Figure J) will open. This may take up to 30 seconds.
®
If the setup screen does not appear, open a browser on the same device and type "192.168.125.1" in the address bar. If the setup screen appears but
is not used (cancelled or otherwise closed), the APak will return to AP mode and the Z Control
setup screen still does not appear, verify your device is still connected to the APak's SSID. If it isn't, repeat Step 2 and be sure your device's Wifi stays
connected to the APak. If your device shows a warning message about no internet or no security on the APak's network, ignore this and connect to it
anyway.
3. On the setup screen (see Figure J), press the WiFi Scan button, scroll down to see the list of WiFi signals found, and choose the WiFi network you want
the APak to use for internet connectivity. Enter the passphrase for the network you chose in the field indicated. If the passphrase is correct, the APak will
connect to the network and start sending status updates to zcontrolcloud.com. You will see the Z Control
to a minute or so.
If the LED does not turn solid, then the passphrase entered is incorrect, the router's security is insufficient (see note below**), or some other network
restriction is in place (see your network administrator). The APak will return to standby mode if the connection to router is not successful. If you need to
force the APak into AP mode again, press the Z Control
transmitting its SSID again. Repeat Steps 2 and 3.
**Note that the APak will not connect to routers with "WEP" or "OPEN" security.
®
Figure I
's SSID
®
button for 12 seconds (See Figure A). This will cause the APak to re-enter AP mode and begin
®
Figure J
Click Wi-Fi Scan button
®
© Copyright 2021 Zoeller
LED will turn off until the next WiFi setup attempt. If the
®
®
Co. All rights reserved.
®
6
LED go from blinking to solid. This could take up
Available Wi-Fi will be listed
®
here. Select the one you want.