Electrical Connection; Initial Use; Setting The Speed; Application Examples - Würth VSG 80 Traducción Del Manual De Instrucciones De Servicio Original

Electrical connection

Attention!
Before initial use, check that the specifications of
your mains power supply correspond to the mains
voltage and mains frequency indicated on the
name plate.
▸
Connect the device to the power supply.
▸
Secure the power cable at the carabineer [19]

Setting the speed

The following diagram is used as an aid to setting
the speed:
Thicker
Steel thick-
550 N/mm²
Steel grade
Bigger

Application examples

Screw Steel S235
Ø in mm Thickness
(mm)
6.3 6
8 6
8 12
Note
The correct setting is to be determined by
trial and error.
Note
The screws to be used depend on the
grade and thickness of the steel
substructure.
16
Thinner
ness
400 N/mm²
Smaller
Screws
Wood Adjustment of the
driving tool
Thickness Gear Speed
(mm)
20 2
40 2
20 1
A guide sleeve [25] and bit [23] to match the head
diameter of the self-drilling screw must be used:
Self-drilling
screw
(Ø mm/Art.)
6.3/0219 864.. AW 30
6.3/0219 664.. AW 30
5.5/0219 955.. AW 30
6.3/0219 063.. AW 30
6.3/0215 963.. AW 30
8.0/0215 98..
8.0/0219 008.. AW 40
Changing the bit (Fig. I/II)
▸
Loosen the locking lever [20].
▸
Take the driving tool out of the bracket.
▸
Counter hold the motor shaft [24] using a 10
mm open-ended spanner and undo and screw off
the retaining nut [22] using a 9 mm open-ended
spanner.
▸
Change the bit [23].
Assembly takes place in reverse order.
Changing the guide sleeve (Fig. I/III)
2
▸
Pull out the index bolt [11]
2
▸
Remove the centring unit [12].
5
▸
Pull the guide sleeve [25] out of the guide
tube [17] and replace.
Assembly takes place in reverse order.
Note
Ensure that the index bolt [11] engages
again.

Initial Use

Guide
AW-bit size
sleeves
(Art.)
Ø
12 mm
(0614 5730)
15 mm
(0614 5730)
15 mm
(0614 5730)
20 mm
(0614 5730)
12 mm
(0614 5730)
AW 40 15 mm
(0614 5740)
15 mm
(0614 5740)