GRAPHITE 59G812 Instrucciones De Uso página 18

●
Never deliberately or unintentionally point the laser beam at people, animals or any other object than
the workpiece.
●
Do not accidentally point the laser beam at the eyes of unauthorised people and animals for the period
longer than 0.25 s, for example by point the laser beam through mirrors.
●
Always make sure the laser beam is pointed at a non-reflective material. Glossy steel plates do not
permit to use the laser beam, since the light might be dangerously reflected towards the operator,
unauthorised people and animals.
●
Do not replace the laser unit with other type devices. All repairs should be performed by the
manufacturer or an authorised person.
NOTE: The tools is intended for indoor works.
Despite using the construction, which is safe by design itself, protection means and additional safety
features, there is always a residual risk of injuries during operation.
Descriptions of used pictograms.
1
1. Read the instruction manual, observe warnings and safety conditions included in it!
2. Use personal protection equipment (safety goggles, ear protectors).
3. Disconnect the power cord, before maintenance or repair works are begun.
4. Keep out of reach of children.
5. Protect against rain
6. Protection class II
Adjustments other than indicated in this instruction manual may expose you to laser radiation!
CONSTRUCTION AND APPLICATION
The mitre saw is a device equipped with the base that provides the possibility to change the angle of the
cutting head attached to it. In addition, depending on a design, the mitre saw head can be tilted at an angle
or slid out to increase the functionality and cutting length.
The mitre saw is designed for cutting wooden pieces that match with the tool size. Do not use the saw for
cutting firewood. Use the mitre saw accordingly to its purpose only. Attempts to use the mitre saw for purposes
other than specified will be considered an improper use. Use the mitre saw only with appropriate cutting discs
with teeth with sintered carbide inserts. The mitre saw is designed for carpentry works in workshops and for
joinery works.
The power tool should be used according to its purpose!
2 3
LASER LIGHT, LASER RADIATION
DO NOT LOOK AT THE LASER BEAM
LASER DEVICE CLASS 2
Wavelength: 650 nm; Output: < 1 mW
EN 60825-1:1994+A2:2001+A1:2002
4
18
6
5