GRAPHITE 59G812 Instrucciones De Uso página 20

When fixing the mitre saw to a workbench ensure that:
●
The workbench top surface is flat and clean.
●
Screws and bolts are tightened equally and moderately (mounting bolts must be tightened so the base is not
stressed or deformed). In case of over-stress there is danger of breaking the base.
DUST EXTRACTION
To prevent dust accumulation and provide maximum efficiency, you can connect the mitre saw to an industrial
vacuum cleaner using the dust extraction connector (28) Alternatively, you can collect the dust in the dust-bag
(included) after installing it onto the dust extraction connector. To install, put the dust bag (29) onto the dust
extraction connector (28) (fig. A). To empty the dust bag, remove it from the dust extraction outlet and open the
zip-fastener that allows to access inside the bag.
To achieve optimal dust extraction empty the bag when it is 2/3 full.
USING THE EXTENSION ARM (HEAD)
There are two positions of the extension arm – upper and lower. To release the extension arm from locked lower
position, do as follows:
●
Press and hold down the extension arm.
●
Pull the head locking pin (
●
Hold the extension arm as it raises to its upper position.
To lock the extension arm in the lower position, do as follows:
●
Press and hold the disc guard lever (
●
Release the pressure downwards onto the extension arm until it is located in its lower position.
●
Lock the extension arm in this position, sliding the head locking pin in (
VERTICAL CLAMP
The vertical clamp (fig. B) can be installed in the saw base at either side of the work table and is fully
adjustable to size of the workpiece to be cut. Do not use the saw without using the vertical clamp.
●
Loosen the vertical clamp mounting knob (
installed.
●
Install the vertical clamp by sliding it into the hole in the mitre saw base and tighten the vertical clamp
mounting knob (30) to the mitre saw base.
●
Once the vertical clamp arm position is adjusted (
locking knob (32) and workpiece mounting knob (33).
●
Make sure the workpiece is secured.
Make sure the mitre saw is disconnected from power supply, before any adjusting or mounting works are
commenced. To ensure safe, precise and efficient operation of the mitre saw, proceed with all adjustment
procedures as a whole.
After finishing all the setting and adjustment procedures, ensure that all spanners are collected. Check
that all threaded connections are properly tightened.
When making adjustments, ensure that all external parts work properly and are in good condition. Any
worn or damaged part must be replaced by qualified personnel before starting to use the mitre saw.
SWITCHING ON /SWITCHING OFF
The mains voltage must correspond to the value specified on the mitre saw nameplate.
Switch on the mitre saw only when the cutting disc is away from the workpiece to be cut.
The mitre saw features the switch lock button (3) that protects against accidental starting.
Switching ON
●
Press the switch lock button (
●
Press and hold the switch button (
9).
5).
30) to the base on the side, which the vertical clamp will be
31) to the workpiece, tighten the vertical clamp arm
OPERATION / ADJUSTMENTS
3).
4).
20
9).