Remote Controls And Accessories - Cebora 553 Manual De Instrucciones

9

REMOTE CONTROLS AND ACCESSORIES

The use of non-original accessories may compromise the correct operation of the power source and even the
integrity of the system, rendering any warranty and liability cover that CEBORA S.p.A. may provide for the welding
power source null and void.
ITEM NO 1341 - Cooling unit for Item No 555.
To be used in conjunction with fluid-cooled torches Item No 1256 and Item No 1258.
Use trolley Item No 1432 to position and transport the welding machine together with the cooling unit.
After filling the tank with coolant fluid, connect the plug of the mains cable to the AE socket of the welding machine, then
connect the free-hanging three-pin male connector to connector AF.
Item No 1260 TIG button only (gas-cooled)
Item No 1256 TIG button only (fluid-cooled)
Item No 1262 TIG UP/DOWN torch. (gas cooled)
Item No 1258 TIG UP/DOWN torch (fluid-cooled)
Item No 193 Pedal-controlled (only used in TIG welding process)
Item No 1180 Connector to connect torch and pedal control at the same time. Item No 193 may be used in any TIG
welding mode with this accessory.
Item No 187 Remote control for regulating welding current (MMA Process only).
Item No 1192 5 m extension cable for remote control Item No 187
Controls that include a potentiometer adjust the welding current from the minimum to the maximum current setting
by means of power source generator.
Controls with UP/DOWN logic control welding current from the minimum to the maximum value.
84/89
NOTICE!
NOTICE!