K2 Pumps SWF05001TPK Manual Del Usuario página 5

TYPICAL EFFLUENT INSTALLATION
1. Electrical wiring and protection must be in accordance with National Electrical Code and any other applicable
state and local electrical requirement.
2. Install proper unicheck (combination union and check valve), preferably just above the basin to allow easy
removal of the pump for cleaning or repair. On effluent, if high head or below cover installation is required use 1-
1/2 in. minimum pipe. See (4) below.
3. All installations require a basin cover to prevent debris from falling into the basin and to prevent accidental injury.
4. When a unicheck is installed, drill a 1/8" (3.2mm) hole in discharge pipe about 1"-2" (2.5 -5.1cm) above quick
connector. The hole must be in the sump
5. Securely tape or clamp the power cord to the discharge pipe, clear of the float mechanism(s).
6. Use full-size discharge pipe.
7. The basin must be in accordance with applicable codes and specifications.
8. The pump must be level and float mechanism(s) clear of the sides of the basin before starting the pump.
9. The basin must be clean and free of debris after installation.
10. The installer must supply the gate valve or ball valve and be installed according to any and all codes.
11. Make sure nothing interferes with switch operation. This pump is preassembled with a piggyback tethered float
switch, please don't change the preassembled switch location.
12. Install the pump stand under the pump to provide a settling basin.
13. Septic tank risers must be used for easy pump and filter access.
14. Double seal pumps offer extra protection from damage caused by seal failure.
All installations must comply with all applicable electrical and plumbing codes, including, but not limited to, National
Electrical Code, local, regional, and/or state plumbing codes, etc. Not intended for use in hazardous locations.
For Professional Technical Support call 1-844-242-2475
Water stream will be visible from this hole during pump run periods.
.
5