Whirlpool 260 Guía De Referencia Rápida página 20

How to build in:
Consider the following minimum
distances to assure adequate air
circulation:
•
10 cm on the sides.
•
10 cm at the rear.
•
15 cm on the top.
10 cm
By doing so you will ensure the
good performance of the product.
You will also prevent Freezer
components from touching walls,
other products or furniture
avoiding unpleasant noise.
Leveling:
To level the Freezer turn
stabilizing feet so that they touch
the floor and lock the product.
To facilitate the closing of the
door, turn the stabilizing feet a
little further, slightly tilting the
product backwards. If necessary,
remove the lower finishing plate.
(pg. 25).
Door reversal:
Your Freezer leaves the factory with
the door opening to the left.
Should the location ask for right-hand
opening for convenience, follow the
step-by-step instructions below.
•
•
15 cm
10 cm
•
17
Unplug the product.
Remove the control panel first by
releasing one of the side locking
clamps with the help of a tool and
at the same time, release the two
lower locks. After that, release the
upper central lock, pressing the
control panel, and if necessary,
release the other side lock.
After releasing them, pull the
control panel to access the hinge.
Remove the control panel
support located on the upper
right-hand side of the product.