Wet Vacuum Cleaning; Close The Suction Connection Illustration; Release And Remove The Suction Head; Pull The Fleece Filter Bag Towards The Rear - Würth ISS 45-M automatic Traducción Del Manual De Instrucciones De Servicio Original

Changeover from wet to dry vacuum
cleaning
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter el-
ement is still wet the filter will become
obstructed and may be damaged be-
yond repair.
 Dry the wet filter properly before use or re-
place it with a dry one.
 Change the filter, if required, according to in-
structions under the section "Maintenance and
Care".
Note: A PES flat fold filter must be used for wet
vacuum cleaning, order no. 0702 400 191.

Wet vacuum cleaning

DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips must
point outwards.
Close the suction connection
Illustration
 Properly insert the connection socket in the suc-
tion connection.
 Push in the connection socket until it locks into
place.
 Turn the suction connection with the connec-
tion socket to the right to close it tightly.
Note: The accurate fit is ensured by means of a
"bayonet connection".
Remove the fleece filter bag
Illustration
 Release and remove the suction head.
 Pull the fleece filter bag towards the rear.
 Pull the locking slide up and seal the fleece fil-
ter bag tightly when removing it.
20
 Dispose of the used fleece filter bag in a dust-

tight bag according to the statutory provisions.

 Insert and lock the suction head.
To suck wet dirt, first remove the fleece filter
–
bag.
Removing the dust disposal bag
Illustration
 Release and remove the suction head.
 Put the disposal bag over.
 Pull the opening of the disposal bag out to-
ward the back over the suction support and
seal it tightly.
 Tightly seal the disposal bag with closure strips
underneath the opening.
 Remove disposal bag.
 Dispose of the disposal bag according to the
local provisions.
 Insert and lock the suction head.
To vacuum wet dirt, always remove the dispos-
–
al bag (option).

Remove the membrane filter.

Illustration
 Release and remove the suction head.
 Remove the membrane filter.
 Insert and lock the suction head.
To vacuum wet dirt, always remove the mem-
–
brane filter (option).
General
If wet dirt is vacuumed with the upholstery or
–
crevice nozzle, or if water is sucked up from a
container, it is recommended to deactivate the
"automatic filter cleaning" function.
If the maximum liquid level is reached the ap-
–
pliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids, oils,
and greases) the appliance is not
turned off when the container is full.
The filling level must be continuously
monitored and the container must be
emptied in time.
GB - 4