Operation - Würth ISS 45-M automatic Traducción Del Manual De Instrucciones De Servicio Original

After completion of the wet vacuuming: Clean
–
the flat fold filter with the filter cleaning device.
Remove and dry the flat fold filter (observe
safety instructions, see care and mainte-
nance). Clean the electrodes using a brush.
Clean the container with a damp rag and dry
it.
Clip connection
Illustration
The suction hose is equipped with a clip system. All
accessories with a nominal width of 35 mm can be
connected.

Operation

Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the main switch.
Adjust the suction output
 Set the suction output (min - max) at the rotary
switch.
Working with electrical power tools
DANGER
Risk of injury and damage! The socket
outlet is only for the connection of power
tools to the vacuum cleaner. Any other
use of the socket outlet is not permitted.
 Connect the mains plug of the electric power
tool to the vacuum cleaner.
 Switch on the appliance at the main switch.
Switch on the automatic remote control:
–
 Press the bottom switch. The vacuum cleaner is
turned on and off automatically with the elec-
tric power tool.
Switch off the automatic remote control:
–
 Press the top switch.
Note: The vacuum cleaner starts automatically
within 0.5 seconds and continues to run for 15 sec-
onds after the power tool has being switched off.
Note: Please refer to "Technical specifications"
for the power connection specifications of the pow-
er tools.
Illustration
 Adjust the tool adapter to fit the connection of
the electric power tool.
Illustration
 Remove the elbow from the suction hose.
 Mount the hose section to the suction hose.
 Mount the tool adapter onto the hose section.
Illustration
 Connect the tool adapter to the electric power
tool.
Note: The different suction hose sections are re-
quired to allow an adjustment to the connection
sections of the processing tools.
 Set the minimum volume flow for the suction
hose cross section at the rotary switch.
The scale displays the suction hose cross section.
Note: To use the appliance as dedusting device
for the mobile operation (processing tool connect-
ed to the vacuum cleaner) the built-in monitoring
must be adjusted to the connected processing tool
(dust-generating device). This means that the user
must be warned if the minimum volume flow of
20 m/s that is required for the suction is fallen
short of.
Note: Please refer to the type plate for the speci-
fication of the minimum volume flow in depend-
ence on the negative pressure.
Automatic filter cleaning
The device is equipped with a filter cleaning device
that is particularly effective with fine dust. The flat
folded filter is automatically cleaned every 15 se-
cods through an air jet (pulsating sound).
Note: Automatic filter dedusting is switched on at
the factory.
Note: The automatic filter dedusting function can
only be switched on/ off when the appliance is
switched on.
To switch off automatic filter cleaning:
–
 Activate the switch. Indicator lamp in the
switch goes off.
To switch on automatic filter cleaning:
–
 Press the switch again. Indicator lamp in the
switch glows green.
GB - 5 21