Controlling The Camera - Nikon WT-2 Manual De Referencia

Controlling the Camera

1
Complete the steps in "Connecting to a Computer" (
2
Start Nikon Capture 4 Camera Control on the
host computer and confi rm that
the camera's top control panel.
3
Control the camera as described in the Nikon Cap ture 4 User's Man u al.
Any photographs taken while the camera is connected will be recorded
directly to the computer hard disk.
Loss of Signal During Transfer
A loss of signal may interrupt the connection while pictures are being transferred to
Nikon Capture 4 Camera Control. If the POWER LED on the WT-2 is blinking (
select Off for the Wireless LAN > Wireless LAN system option in the camera setup
menu and then select On again. Transfer will resume when the connection is re-estab-
lished. Do not turn the camera off. Transfer can not be resumed once the camera
is turned off.
Connecting to Multiple Computers
Any computer enabled in the connection list can connect to the camera when running
Nikon Capture 4 Camera Control. Note, however, that attempting to control the cam-
era simultaneously from multiple computers may produce unexpected results. Nikon
recommends disabling the other connections if you are unsure whether the other com-
puters in the connection list are running Nikon Capture 4 Camera Control (
is displayed in
20).
22),
36).
21