Gianantoni - Genius SPRINT 11 SW Instrucciones Para El Uso

Pagina 1 SPRINT 11 SW
Guide for the installer
1. GENERAL CHARACTERISTICS
2. TECHNICAL SPECIFICATIONS
2.1. PROTECTIVE FUSES
3. PREPARATIONS
4. BOARD LAYOUT
5. CONNECTIONS AND OPERATION
5.1. JP1 CONNECTOR
5.2. CN1 TERMINAL BOARD
5.3. CN2 TERMINAL BOARD
5.4. CN4 TERMINAL BOARD
5.5. BATTERY KIT
6. INSTALLATION OF THE RECEIVER BOARD
7. OPERATIONAL PARAMETERS
8. VIRTUAL ENCODER OPERATION
9. ADJUSTMENT OF MOTOR POWER
10. PROGRAMMING
11. MEMORY STORING THE RADIO CODE
11.1. Memory storage of 868 MHz radio controls
11.2. Memory storage of 433 MHz radio controls
11.3. Deletion of radio codes
12. CONTROL LEDS
13. POSITIONING THE TRAVEL LIMIT MAGNETS
14. FUNCTION LOGICS
Manufacturer: GENIUS S.p.A.
Address: Via Padre Elzi, 32 - 24050 - Grassobbio- Bergamo - ITALY
Declares that: Control unit mod. SPRINT 11 SW
• conforms to the essential safety requirements of the following EEC directives:
• 2006/95/EC Low Voltage directive.
• 2004/108/EC Electromagnetic Compatibility directive.
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by GENIUS S.p.A.).
Grassobbio, October 22, 2009
Read this installation manual to the full before you begin installing the product.
The symbol indicates notes that are important for the safety of persons and for the good condition of the automated
The symbol draws your attention to the notes on the characteristics and operation of the product.
CE DECLARATION OF CONFORMITY
Notes on reading the instruction
INDEX
system.
page.13
page.13
page.13
page.13
page.14
page.14
page.14
page.15
page.15
page.16
page.16
page.16
page.17
page.17
page.18
page.18
page.19
page.19
page.19
page.20
page.20
page.20
page.21
Managing Director
D. Gianantoni