Concerning The Wireless Remote Controller (Optional Accessory) - Panasonic GP-VD151 Instrucciones De Operación

Concerning the wireless remote controller (optional accessory)

This unit can be operated by remote control using a
wireless remote controller (model number: AW-RM50G)
which is sold separately.
The unit cannot be operated directly using the wireless
remote controller of an HD visual communication unit.
Check out the following points before using the wireless
remote controller.
Consult your dealer concerning the purchase of a
wireless remote controller.
p p Operate the wireless remote controller from positions
less than 6 m {19.7 feet} away from the unit.
p p The wireless remote controller may not work when it
is pointed from certain angles at the unit.
From a place where the wireless remote controller signal
light-sensing area (hereafter, "light-sensing area") can
be seen, point the signal transmission window of the
wireless remote controller at the light-sensing area, and
operate the buttons.
It may prove to be more difficult to operate the unit when
the remote control is operated from behind the unit.
p p If the unit is installed near fluorescent lights, plasma
monitors or other such products or if the unit is
exposed to sunlight, the effects of the light may make
it impossible for the unit to be operated using the
wireless remote controller.
Be sure to follow the steps below for installation and use.
• Take steps to ensure that the light-sensing area will not
be exposed to the light from fluorescent lights, plasma
monitors or other such products or from the sun.
• Install the unit away from fluorescent lights, plasma
monitors and other such products.
p p For about 10 minutes even after the batteries have
been removed from the wireless remote controller,
the selection of the operation to be performed (the
[CAM1], [CAM2], [CAM3] or [CAM4] button which
was pressed last) will remain stored in the memory.
When a longer period of time elapses, however, the
selection is reset to the status established when the
[CAM1] button was pressed.
13 (E)