RAASM 290 Serie Manual De Instrucciones página 14

Ocultar thumbs Ver también para 290 Serie:
Tabla de contenido

Publicidad

- Prima della messa in servizio
dell'avvolgitubo effettuare il
controllo della messa a terra
(vedi disegno) mediante
esame visivo del cavo e del
morsetto ed eventuale misura
della resistenza, in modo da
garantire la protezione contro
i rischi derivanti dall'accumulo
di cariche elettrostatiche.
- E' vietato l'uso di fiamme
libere e lavorazioni a caldo in
prossimità dell'avvolgitubo.
Non esporre l'avvolgitubo e il
tubo stesso a fonti di calore.
- L'impianto elettrico e le
attrezzature elettriche installate
nei pressi dell'avvolgitubo
devono essere conformi
ai requisiti richiesti dalla
classificazione in zone
previsti dalla ATEX. Devono
inoltre ottemperare alle altre
disposizioni legislative vigenti
nel paese di appartenenza.
- Durante le operazioni di pulizia
dei raccordi o in genere delle
parti interne, utilizzare prodotti
compatibili con i fluidi utilizzati.
In particolare per i componenti
a contatto con l'ossigeno non
si devono utilizzare solventi a
base di idrocarburi, sostanze
NL
- Alvorens de slanghaspel
in gebruik te nemen moet
gecontroleerd worden of de
aarding deugdelijk is (zie de
tekening) door de kabel en de
klem visueel te controleren en
door de weerstand eventueel
op te meten om bescherming
tegen de risico's vanwege de
ophoping van elektrostatische
ladingen te kunnen bieden.
- Het gebruik van open vuur
en het uitvoeren van hete
bewerkingsprocessen in de
buurt van de slanghaspel is
verboden. De slanghaspel en de
slang mogen niet blootgesteld
worden aan warmtebronnen.
- De elektrische installatie en de
elektrische apparaten die in
de buurt van de slanghaspel
geïnstalleerd zijn moeten aan
de eisen i.v.m. de classificatie
in zones zoals bepaald door
de ATEX voldoen. Bovendien
moeten zij aan de andere
wettelijke voorschriften die in
het land waar de apparatuur
opgesteld is gelden voldoen.
- Tijdens het schoonmaken
van de aansluitkoppelingen
of van de inwendige delen
in het algemeen moeten
-14-
- Before using the hose reel
control the earth system (see
diagram) by visually checking
the cable and terminal and
possibly measuring the
resistance, in order to guarantee
protection against risks
arising from the accumulation
of electrostatic charges.
- Do not use naked flames
or carry out hot work
near the hose reel. Do not
expose the hose reel and
the hose to heat sources.
- The electrical system and
electric equipment installed
near the hose reel must
comply with the requirements
of the classification in zones
provided for by ATEX. They
must also comply with the
current legal provisions in
the relevant country.
- During cleaning of the
connections or the internal
parts in general, use products
compatible with the fluids
used. In particular for the
components in contact
with oxygen do not use
hydrocarbon-based solvents,
oily or greasy substances, as
this could cause spontaneous
DK
- Kontrollér jordforbindelsen,
inden slangetromlen tages
i brug (se tegningen). Dette
sker ved at udføre en synlig
kontrol af kablet og klemmen
og eventuelt måle modstanden.
Herved er det muligt at sikre
beskyttelse mod risiciene
som følge af akkumulation af
elektrostatiske ladninger.
-Det er forbudt at benytte åben
ild og udføre forarbejdninger
ved høje temperaturer i
nærheden af slangetromlen.
Udsæt ikke slangetromlen
og slangen for varmekilder.
- Det elektriske system og de
elektriske apparater, som
er installeret i nærheden
af slangetromlen, skal
opfylde kravene vedrørende
Atex-mærkningens
områdeklassifikation. Endvidere
er det nødvendigt at overholde
de øvrige bestemmelser i
den nationale lovgivning.
- Benyt produkter, som er
kompatible med de anvendte
gasser, i forbindelse med
rengøring af koblingerne eller
andre indvendige dele. Specielt
gælder det, at der ikke må
benyttes opløsningsmidler med

Publicidad

Tabla de contenido
loading

Tabla de contenido