ENGLISH
4
Introduction
Full-body tanner with integrated facial tanning unit
With this tanning appliance you can suntan comfortably at home.The tanning lamps emit visible light, heat and ultraviolet light, giving you the
impression you are sunbathing in real sunlight.This appliance tans your whole body, including the sides, evenly from head to toe.
A timer ensures that each tanning session does not last longer than 30 minutes. Just as with natural sunlight, overexposure must be avoided
(see chapter 'Tanning and your health').
General description (fig. 1)
A Tube lamps and starters of the couch
B Tube lamps and starters of the canopy
C Facial tanner
D Switches for facial tanner
- O = facial tanner off
- I = facial tanner on
- I and , = facial tanner on at 75% of its full intensity
- I and m = facial tanner on at full intensity
E Fan for body cooling
F Switches for fan
- O = fan off
- I = fan on
- I and n = one fan on
- I and b = both fans on
G End cover
H Mains cord
I Legs of the frame
J Connecting cables between power supply unit and couch and canopy
K Fans to cool the facial tanners
L Vents and fans to cool the tube lamps
M Acrylic sheets
N Protective foils
O Protective goggles (2 pairs)
- (type no. HB072/service no. 4822 690 80147)
P Screws, bolts and decorative caps
Q Spanner and screwdriver
R Timer
S Power supply unit
Important
Check if the voltage indicated on the canopy corresponds to the mains voltage in your home before you connect the appliance.
This appliance requires a mains voltage of 400 volts.
A high mains impedance may result in noticeable light intensity changes from light bulbs when the tanning appliance is switched on.To
fulfil the legal EMC requirements on this point, the modulus of the mains impedance has to be lower than 0.3 ohm. For information,
contact your utility.
Water and electricity are a dangerous combination! Do not use this appliance in wet surroundings (e.g. in the bathroom or near a
shower or swimming pool).
If you have just been swimming or have just taken a shower, dry yourself thoroughly before using the appliance.
The appliance must be connected to a three-phase power supply that is protected with 16A standard fuses or automatic fuses.
Always unplug the appliance after use.
Make sure the cord does not become trapped under one of the legs when you move the appliance.
Make sure the vents to cool the tanning lamps in the canopy and in the couch remain open during use.
Never use the appliance when the timer or an acrylic sheet is defective.
Make sure children do not play with the appliance.
Do not exceed the recommended tanning time and the maximum number of tanning hours (see 'Tanning sessions: how often and how
long?').
Do not tan a particular part of your body more than once a day.Avoid excessive exposure to natural sunlight on the same day.
Do not use the tanning appliance if you have a disease and/or use medication or cosmetics that increase the sensitivity of your skin. Be
extra careful if you are hypersensitive to UV light. Consult your doctor in case of doubt.
Consult your doctor if persistent lumps or sores appear on the skin, or if there are changes in pigmented moles.
The appliance is not to be used by people who get sunburnt without tanning when exposed to the sun, by persons suffering from
sunburn, by children, or by persons who suffer (or have previously suffered) from skin cancer or who are predisposed to skin cancer.
Always wear the protective goggles provided with the appliance while tanning to protect your eyes against overexposure (also see
'Tanning and your health').
Remove creams, lipstick and other cosmetics well in advance of a tanning session.
Do not use any sunscreens or suntan accelerators.
If your skin feels taut after the tanning session, you may apply a moisturising cream.
Colours may fade under the influence of the sun.The same effect may occur when using this appliance.
Do not expect the appliance to yield better results than the natural sun.
If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips in order to
avoid hazardous situations.
If you require another type of plug than the one fitted to the appliance, please contact a registered electrician.