Publicidad
SIDE MOUNTING
INSTRUCTIONS
STEP 1
Attach the side mount brackets
to the front of the slides using
(4) M4x10 flathead screws
(See Fig 1).
STEP 2
Place side mounting template
to side of cabinet and
pre-drill hole locations (See Fig
2) and install the cabinet side
mounting brackets.
3
32
3
mm
STEP 3
Place the slide assembly on
top of the cabinet mounting
bracket, insert (4) M4x10
flathead screws, adjust to the
desired width of basket and
tighten the screws. Repeat for
the opposite side (See Fig 3).
STEP 4
Install release levers and rear
slide brackets to the bottom of
the unit (See Fig 4).
NOTE: If you are mounting to
a cabinet door, skip to Page 4
at this time.
STEP 5
Place the basket on top of the
slides and push back until the
basket locks under the tab
at the rear and at the button
on the side. You should hear
the button click when fully
engaged (See Fig 5).
INSTALLATION INSTRUCTIONS: 5330/5386 SERIES PULLOUT BASKET WITH SOFT-CLOSE
FIGURE 1
FIGURE 4
#6x3/4" Flat Head Screws (4)
FIGURE 2
FIGURE 3
Euro Screws (4)
FIGURE 5
3
Publicidad
