STACK-ON PC-1702-RFID Manual De Instrucciones página 6

TURNING THE KEYPAD SOUND
OFF/ON
Your case comes with the "Beep" sound
turned on. You can turn off the "Beep" sound
of the keypad by pressing RFID button
and holding for 3 seconds until the panel
flashes green then purple.
To turn the "Beep" sound on, press the RFID
button and hold for 3 seconds until the
panel flashes green then purple.
CLEARING ALL CODES
Clearing the codes will erase the signature of the
programmed RFID devices and the programmed
electronic combination.
Locate the reset button on the inside of the case
and press and hold until the green light flashes and
beeps 10 times (if the sound is turned on).
NOTE: Failure to follow instructions
will not erase the codes.
All recorded devices and combination will be
erased. You will need to reprogram all devices and
the combination described in the Programming
Sections of this instruction sheet.
NOTE: This unit is not an approved California
Department of Justice firearm safety device.
IMPORTANT
Keep keys, RFID devices and your combination
number is a secure place, away for children.
Keep this record of your serial number and
combination in a secure place separate from your
case. To order a replacement RFID device, or key
set, follow the instructions on the attached form.
STACK-ON PRODUCTS CO.
®
P.O. BOX 489, WAUCONDA, IL 60084
6
16
40720-1704