Cleaning And Maintenance; Service Centre; Environmental Information - Grouw 18122 Manual De Instrucciones

4. The top of the fi le should protrude
approximately 1/5 up above the tooth.
5. Finally, fi le any riders using a depth-
gauge tool and a fl at fi le. The riders
must all have the same height and be
approximately 0.65 mm lower than the
teeth.

Cleaning and maintenance

Clean the chainsaw by wiping exterior parts
with a damp cloth. Ensure the ventilation
slots are kept free of dust and dirt.
Never use corrosive or abrasive cleaning
agents, as they may attack the plastic parts of
the chainsaw.
Remove the saw chain and blade regularly
and clean the groove in the blade. Remove
the cover and brush the area around the
chain wheel and the chain tensioner using a
soft brush.
Sharpen the teeth using a chainsaw fi le or
grinder. Be very careful when sharpening the
teeth!
Replace the saw chain when the teeth are
worn down to the mark.
Refi ll the chain oil tank with chain oil before
each use and once the oil level falls below
the minimum mark on the oil gauge.
Check for blade and chain wheel wear
regularly and replace if necessary.
Always place the protective cover (15) on
the blade when transporting or storing the
chainsaw.
60

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacement parts
• Returns
• Guarantee issues
• www.schou.com

Environmental information

Electrical and electronic equipment
(EEE) contains materials,
components and substances that
may be hazardous and harmful to
human health and the environment
if waste electrical and electronic equipment
(WEEE) is not disposed of correctly. Products
marked with a crossed-out wheeled bin are
electrical and electronic equipment. The
crossed-out wheeled bin indicates that waste
electrical and electronic equipment must
not be disposed of with unsorted household
waste, but must be collected separately.
Manufactured in P.R.C.
Manufacturer:
Schou Company A/S
Nordager 31
DK-6000 Kolding
All rights reserved. The content of this manual may not
be reproduced, either in full or in part, in any way by
electronic or mechanical means, e.g. photocopying or
publication, translated or saved in an information storage
and retrieval system without written permission from
Schou Company A/S.