Operation; Switching On And Off; Selecting Speed And Abrasive Belt (Continuous Operation) - Parkside PBS 900 C3 Traducción Del Manual De Instrucciones Original

Dismantling/removing the dust collector:
♦ Pull the dust collector
Dust extraction adapter (with reducer )
(see fig. C):
♦ Push the dust extraction adapter
extraction nozzle
ducer by pushing it onto the dust extraction
adapter .
♦ Push the hose from a suitable dust extraction
appliance (e.g. a workshop vacuum cleaner)
onto the dust extraction adapter
reducer if necessary.
Removal:
♦ Pull off the dust extraction device hose.
♦ Pull the dust extraction adapter
the reducer , if attached).

Operation

Switching on and off
While operating the belt sander, you can choose
between instantaneous and continuous operation.
Switching to instantaneous operation:
♦ Press the ON/OFF switch
Switching off instantaneous operation:
♦ Release the ON/OFF switch
Adjusting the rotational speed (instantaneous
operation)
Press the ON/OFF switch
speed. Increasing the pressure increases the speed.
Switching to continuous operation:
♦ Press the ON/OFF switch
in and then press the lock button
Switching off continuous operation:
♦ Press the ON/OFF switch
it.
PBS 900 C3
off the appliance.
onto the
. If necessary, use the re-
; use the
off (and also
.
.
lightly for a low
, keep it pressed
.
and then release
Selecting speed and abrasive belt
(continuous operation)
You can use the speed preselector wheel
adjust the speed, while the appliance is running
( – = lower speed, + = higher speed). The optimum
belt speed is dependent on the workpiece or ma-
terial being processed. We recommend carrying out
a practice run to determine the correct speed. In
the table below, you will find some recommended
values which will help you determine which belt
and speed to use for which job.
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
to
Softwood
60
240
high
Hardwood
60
180
high
Chipboard
60
150
high
Removing paint/
varnish
60
––
high
GB │ IE │ 17 ■