Required Tools - Merrithew SPX Reformer Manual Del Propietário

Removing the Springs
. With 7/16" wrench, hold xed cube nut in place.
1
. Remove spring from spring anchoring bar.
3
. Repeat steps 1 to 4 on remaining springs.
5
Spring Anchoring Bar
Fixed Cube Nut
. Using second 7/16" wrench on opposite side of spring
2
anchoring bar, loosen nylon locknut. This may require exerting
NOTE:
locknuts and washers are provided with new springs.)
. Pull spring out of the spring holder.
4
. Remove spring sleeves from old springs and slide onto
6

Required Tools

2x Open-End Wrenches
1/2" x 7/16" (13 mm x 11 mm)
Discard used nylon locknuts and washers. (New nylon
13