Broan beot K7388 Manual Del Usuario página 5

INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions
will reduce the performance of the hood.
Use as few of them as possible. Larger
ducting may be required for best
performance with longer duct runs.
4. Install a roof or wall cap. Connect round
metal ductwork to cap and work back to-
wards hood location. Use duct tape to seal
the joints between ductwork sections.
INSTALL MOUNTING
BRACKET
1. Construct wood wall framing that is flush
with interior surface of wall studs.
Make sure:
a) the framing is centered over
installation location.
b) the height of the framing will allow the
mounting bracket to be secured to
the framing within the dimensions
shown.
2. After wall surface is finished, secure
mounting bracket to framing using dimen-
sions shown.
INSTALL THE
HOOD
1. Hang the hood from the
bracket through the
rectangular cut-out on
the back of the hood. Cut-
out is larger than the
bracket to allow for
horizontal adjustment.
The bottom of the hood
should be 24" to 30"
above the
surface.
2. Secure the hood with
mounting screws. Use drywall anchors, provided, if wall studs or framing are
not available.
MOUNTING
SCREWS
cooking
DECORATIVE
FLUE
HOOD
24" TO 30" ABOVE
COOKING SURFACE
36-13/16"= bottom of hood 24" above
cooktop
42-11/16"= bottom of hood 30" above
cooktop
MOUNTING
SCREWS
- 5 -
ROOF CAP
ROUND DUCT
ADAPTER
FRAMING BEHIND DRYWALL
WALL FRAMING
MOUNTING
BRACKET
RECTANGULAR
CUTOUT
WALL
CAP
ROUND
ELBOW
6"