Rev-A-Shelf 5LB Serie Instrucciones De Instalación página 3

STEP 4
Place the Rev-A-Shelf logo
caps on both sides of the
LEGRABOX (See Fig 4).
STEP 5
Use the measurements from
Figure 5 to mark the door
mounting hole locations
(recommended with an awl and
rubber mallet).
STEP 6
Install the door brackets to the
door with the #6 x 1/2" screws
included with the RV Door
Mount screw pack
(See Fig 6).
NOTE: Make sure not to drill
through the door.
NOTE: Each pack contains
(2) extra screws. Discard any
extras you don't need.
#2
STEP 7
Align the door brackets to
the locks on the front of the
LEGRABOX frame and push
until you hear a "click" sound
(See Fig 7).
STEP 8
If your LEGRABOX needs to
be adjusted to fit the door
properly, first remove the
cover caps (See Fig 8).
1-1/4" (32 mm)
1-1/4" (32 mm)
3-25/32" (96 mm)
1-1/4" (32 mm)
2" (51 mm) + Overlay
9/16" (14mm) + Overlay
FIGURE 7
INSTALLATION INSTRUCTIONS: 5LB SERIES LEGRABOX WASTE CONTAINER
FIGURE 4
FIGURE 5
Finding The Overlay
The overlay equals the door
height minus the cabinet
opening height divided by 2.
For example, if a door is 24"
(610 mm) tall, and the cabinet
opening is 23" (584 mm) tall:
24-23=1
1÷2 = .5
The overlay = 1/2" (13 mm)
9/16" (14 mm) + Overlay
9-13/32" (239 mm) - Single 30 qt. container width
12-13/32" (315 mm) - Single 35/50 qt. container width
15-13/32" (391 mm) - Double 35/50 qt. container width
FIGURE 6
REMOVE CAP
REMOVE CAP
1-1/4" (32 mm)
1-1/4" (32 mm)
3-25/32" (96 mm)
1-1/4" (32 mm)
2" (51 mm) + Overlay
FIGURE 8
3