Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8.5 - Memorising a transmitter in "Mode I", using another memorised transmitter
Caution! – To use this procedure, a second transmitter which has already been memorised is necessary, a so-called "old" transmitter. This procedure mem-
orises the NEW transmitter in "Mode 1" regardless of the Mode with which the OLD transmitter was memorised.
Warning – To cancel the procedure during execution, press buttons n and t on the transmitter at the same time and hold them until the blind carries out 6
movements, then release the buttons.
01
8
sec.
New
01. (on the new transmitter) Press and hold button n for 8 seconds then
release it.
02. (on the old transmitter) Briefly press button n 3 times.
03. (on the new transmitter) Briefly press button n once: the blind com-
pletes 3 movements.
8.6 - Memorising a transmitter in "Mode II", using another memorised transmitter
Caution! – To use this procedure, a second transmitter which has already been memorised is necessary, a so-called "old" transmitter. This procedure mem-
orises one button of the NEW transmitter in "Mode II", regardless of the Mode with which the button of the OLD transmitter was memorised.
Warning – To cancel the procedure during execution, press buttons n and t on the transmitter at the same time and hold them until the blind carries out 6
movements, then release the buttons.
01
01
8
sec.
New
03
Old
04
New
01. (on the new transmitter) Press and hold button s for 8 seconds then
release it.
02. (on the old transmitter) Press and hold any button (e.g. button n) for a
few seconds and release it after the blind has completed 2 move-
ments.
03. (on the old transmitter) On the same button pressed at point 02, press
the same number of times as the number associated with the com-
mand to be memorised:
1 press = Up command
2 presses = Up command after 10 seconds
3 presses = Up command after 20 seconds
4 presses = Down command
5 presses = Stop command
02
Old
02
Old
x 1 = Up command
x 2 = Up after 10 seconds command
x 3 = Up after 20 seconds command
0,5
x 4 = Down command
sec.
x 5 = Stop command
3
5
sec.
X 3
0,5
sec.
New
2
5
sec.
?
3
sec.
Then, after 3 seconds the blind completes the same number of move-
ments as the number of times the transmitter button is pressed.
04. (on the new transmitter) Press and hold button s for a few seconds and
release it after the blind completes 3 movements. Note – If the blind
makes 6 movements it means the motor memory is full.
03
3
0,5
sec.
1 /
2 /
3 /
4 /
5 /
THE
END
English – 8
Publicidad
Tabla de contenido
