Tripp-Lite B140-101 El Manual Del Propietario página 21

Extender/Splitter Daisy-Chain Installation
1
Make sure the DVI source is powered OFF.
2
Connect the DVI source to the DVI port on the B140-004 labeled INPUT
using a Tripp Lite P561-Series DVI-D Single Link Cable.
3
Connect the external power supply to the B140-004 local unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green RJ45 LEDs
and red Power LED will illuminate to indicate power is being received
from the external power supply.
4
Using the included DVI daisy-chain cable, connect the OUTPUT DVI port
on the first B140-004 to the INPUT DVI port on a second B140-004.
5
Connect the external power supply to the B140-004 local unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green RJ45 LEDs
and red Power LED will illuminate to indicate power is being received
from the external power supply.
6
Repeat steps 4 and 5 if you are connecting a third B140-004.
7
Optional: Connect a DVI monitor to the OUTPUT DVI port on the last
B140-004 using a Tripp Lite P561-Series DVI-D Single Link Cable.
8
Using Cat5e/6 cable, connect one of the RJ45 output ports on a local
unit to the RJ45 input port on a B140-1P0, B140-1A0 or
B140-1A0-WP-1 remote unit.
9
Repeat step 8 for each additional remote unit you are connecting.
10
B140-1A0 and B140-1A0-WP-1 only: Connect the external power
supply to the B140-1A0 or B140-1A0-WP-1, and plug it into a
Tripp Lite Surge Protector, PDU or UPS. The green RJ45 LEDs on the
B140-1A0 and the green LED on the B140-1A0-WP-1 illuminate to
indicate the unit is receiving power.
11
Repeat step 10 for each additional B140-1A0 or B140-1A0-WP-1 in the
installation.
17-08-508-933776.indb 21
21
11/27/2017 11:47:50 AM