Tripp-Lite B140-101 El Manual Del Propietario página 25

Extender/Splitter Daisy-Chain with Remote/
Repeater Installation
and B140-1A0 and B140-1A0-WP remote receivers only)
Up to four units can be daisy chained (three remote/repeaters and one
receiver). To connect additional remote/repeater units, proceed to step
11. To finish your installation with a B140-1A0 or B140-1A0-WP-1 remote
receiver unit, proceed to step 15.
11
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the first remote/
repeater unit to the RJ45 INPUT port on a second remote/repeater unit.
12
Connect a monitor to the DVI OUTPUT port on the remote/repeater unit
that you just added using a Tripp Lite P561-Series DVI-D Single Link
Cable.
13
Connect the external power supply to the remote/repeater unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green Power LED
and the green RJ45 LEDs illuminate to indicate the unit is receiving
power.
14
To add a third remote/repeater unit, repeat steps 11 through 13. To
finish your installation with a B140-1A0 or B140-1A0-WP-1 remote
receiver unit, proceed to step 15.
15
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the last remote/
repeater unit to the RJ45 INPUT port on a B140-1A0 or B140-1A0-WP-1
remote receiver unit.
16
Connect a monitor to the DVI OUTPUT port on the remote receiver unit
using a Tripp Lite P561-Series DVI-D Single Link Cable.
17
Connect the external power supply to the remote receiver unit and plug
it into a Tripp Lite Surge Protector, PDU or UPS. The green RJ45 LEDs on
the B140-1A0 and the green LED on the B140-1A0-WP-1 illuminate to
indicate that the unit is receiving power.
17-08-508-933776.indb 25
(B140-004 extender/splitter,
25
11/27/2017 11:47:51 AM