Kohler K-1418-H2 Guia De Instalacion página 2

Roughing-In
11-3/4"
(29.8cm)
36" (91.4cm)
20-1/8"
(51.1cm)
1-1/2" O.D.
Product Information
Drop-in whirlpool
Required accessories:
Jet trim kit
Fixture*: basin area
Bathing well 48" (121.9cm) x
27" (68.6cm)
water depth
To overflow 16" (40.6cm)
* Approximate measurements for comparison only.
Pump Heater Voltage
1.5 HP 1.5 kW 240 V
Required Electrical Service
Dedicated circuit required, protected with Class A Ground-Fault
Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB):
Pump/control
A
1022381-1-
K-1418-H2
5-1/4" (13.3cm)
72" (182.9cm)
3" (7.6cm)
1-1/16" (2.7cm)
K-1418-H2 shown
K-9698
top area weight
60" (152.4cm) x 140 lbs.
30" (76.2cm) (63.5kg)
capacity
94 gal. (355.8L)
Frequency Amperage
50/60 Hz 11 A
220/240 V, 20 A, 50/60 Hz
No change in measurements if connected with drain illustrated.
(K-7161-AF or K-7161M-AF)
Drop-in cut-out 70-1/2" (179.1cm) x 40-1/2" (102.9cm)
Minimum access panel:
Pump/control 34" (86.4cm) W x
15" (38.1cm) H
PUMP/CONTROL ACCESS
22"
(55.9cm)
Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
1600 lbs. (725.7kg)
Hot water supply should be 70% of capacity or greater. Installations
will vary.
If installing a rim mount faucet, make sure there is no interference
with drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
This whirlpool is designed for drop-in installation only. It is not suited
for use in a three wall alcove with an overhead shower.
Fixture conforms to ANSI Standard Z124.1. All dimensions are
nominal.
2
required
42" (106.7cm)
2-7/8" (7.3cm)
3" (7.6cm)
Kohler Co.