Kit Assembly; Iso Din Radio Provision With Pocket - Metra 99-3321B Manual De Instrucciones

ISO DIN radio provision with pocket

1. Slide the radio brackets into the radio
housing, aligning the holes in the radio
housing to the clips on the brackets.
(Figure A)
2. Attach the pocket to the lower section
of the radio brackets using the (4) #8 x
3/8" Phillips screws provided. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket
assembly, and then secure it using the
screws supplied with the radio. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra or AXXESS. Test
the radio for proper operation .
6. Secure the completed assembly into the
dash, and then reassemble the dash in
reverse order of disassembly.
Suzuki XL-7 only: Trim the top corners of
the radio housing. (Figure C)

KIT ASSEMBLY

(Figure A) (Figure B) (Figure C)
REV. 10/24/2017 INST99-3321B
9