Getting Started
Resetting the unit
Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel and press the RESET
button with a pointed object, such as a ballpoint
pen.
RESET
button
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
Setting the clock
The clock uses a 24-hour digital indication.
OFF
SRC
SOUND
ENTER
SETUP
SYSTEM
SYSTEM
MENU
MENU
Z × Z
AUDIO SUBTITLE
1
Press (SYSTEM MENU).
The setup display appears.
2
Press M/m repeatedly until "CLOCK-
ADJ" appears.
3
Press (ENTER).
The hour indication flashes.
4
Press M/m to set the hour and minute.
To move the digital indication, press </,.
5
Press (ENTER).
The clock starts.
To display the clock during playback/reception,
set "CLOCK-ON" (page 36).
8
ATT
DVD
MODE
+
TOP MENU
MENU
ENTER
–
LIST
</,
PICTURE
EQ
DSO
EQ7
ANGLE
DEMO mode
When the unit is turned off, the clock is
displayed first, then demonstration (DEMO)
mode starts the demonstration display.
To cancel the DEMO mode, set "DEMO-OFF"
in setup (page 36) while the unit is turned off.
Detaching the front panel
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OFF).
The unit is turned off.
2
Press
M/m
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
Tip
When carrying the front panel, use the supplied front
panel case.
, then pull it off towards you.
(OFF)