Omnifilter SFM3 Instrucciones De Instalación página 3

INSTALLATION INSTRUCTIONS
2. Selecting the Faucet Location
NOTE: The drinking water faucet should be positioned with function,
convenience, and appearance in mind. An adequate flat area is
required to allow faucet base to rest securely. The faucet fits through a
3/4-inch hole. Most sinks have pre-drilled 1
holes that may be used for faucet installation. If these pre-drilled holes
cannot be used or are in an inconvenient location, it will be necessary
to drill a 3/4-inch hole in the sink to accommodate the faucet.
CAUTION
This procedure may generate dust which can cause severe
irritation if inhaled or come in contact with the eyes. The use of safety
glasses and respirator for this procedure is recommended.
CAUTION
Do not attempt to drill through an all-porcelain sink. If you
have an all-porcelain sink, mount the faucet in pre-drilled sprayer hole
or drill through countertop next to sink.
CAUTION
When drilling through a countertop, make sure the area
below the drilled area is free of wiring and piping. Make certain that
you have ample room to make the proper connections to the bottom
of the faucet.
CAUTION
Do not drill through a countertop that is more than
one inch thick.
CAUTION
Do not attempt to drill through a tiled, marble, granite or
similar countertop. Consult a plumber or the countertop manufacturer
for advice or assistance.
A) Line bottom of sink with newspaper to prevent metal shavings,
parts, or tools from falling down drain.
B)
Place masking tape over the area to be drilled to prevent scratches
if drill bit slips.
C) Mark hole with center punch. Use a 1/4-inch drill bit for a
pilot hole.
D)
Using a 3/4-inch drill bit, drill a hole completely through the sink.
Smooth the rough edges with a file.
3. Mounting the Faucet
A) Remove wing nut , and metal washer
3
shaft of the faucet. Leave the black rubber washer
threaded shaft.
B) Slide the threaded shaft of the faucet into drilled hole.
C) From under the sink, slide the metal washer on and thread on
the wing nut. Tighten the wing nut by hand until tight. It may
be necessary to have a second person to hold the faucet while
tightening the wing nut.
NOTE: Do not over-tighten the wing nut. Hand-tighten only. Do not
use pliers or wrench to tighten.
4. Mounting the System
A)
Select location under sink or in basement where filter is to
be mounted.
NOTE: Allow 1 ⁄ -inch (38 mm) clearance below housing or
1
2
11-inch below filter head to enable filter cartridge changes.
CAUTION
Filter head should be mounted on stud or firm surface.
The mounting bracket will support the weight of the filter and
help prevent strain on the cold water line.
B) Filter head should be mounted in vertical position, use mounting
bracket as a template to mark screw locations. Mount filter head
in marked location using screws.
CAUTION
Water supply to the filter should have a separate shut
off valve. If it does not, a separate shutoff should be installed.
CONTINUED
⁄ -inch or 1 ⁄ -inch diameter
3 1
8 2
, from the threaded
2
, on the
1
2
C
D
3
1
2
4
B
A
3
• 3 •