Festo CPX-P-8DE-N Manual De Instrucciones página 23

2. Align the connection block over the interlinking block
with the electronics module. When doing this make
sure the plug connectors of the connection block are
aligned exactly with the connectors of the electronics
module. Then push the connection block carefully and
without tilting onto the interlinking block.
3. The four screws should only be tightened by hand.
Then tighten all four screws in diagonally opposite
sequence with a Torx screwdriver size T10 - tightening
torque 1 Nm ±10 %.
The lower right-hand screw is used internally as an earth-
ing contact between the interlinking block and the connec-
tion block.
3.3 Dismantling the module
Dismantling the connection block
1. Loosen the 4 screws from the relevant connection
block by using a Torx screwdriver size T10.
2. Pull the connection block carefully and without tilting
away from the electrical plug connection of the elec-
tronics module.
Dismantling the electronics module
• Pull the electronics module carefully and without tilt-
ing away from the contact rails of the interlinking
block.
Festo CPX-P-EA 1209NH English 23